Energy-saving Of Non-clogging Swirl Pumps

　　Energy-saving for non-blocking cyclone pump*　　There are two types of discrete and horizontal types of cyclone pumps. The impeller is a cyclone impeller, which is suitable for transporting corrosive liquids containing less than 45% solid particles (particle size less than 20mm).The pump housing and impeller adopt a novel design concept. The impeller rotates in the pump body. The internal tension of the medium drives the medium in the pump body flow channel to form a vortex to obtain kinetic energy. The medium in the pump body flow channel is thrown out through the pump body outlet, and the medium between the impeller and the impeller blades do not move relative to each other, which greatly extends the service life of the impeller, which is three times the life of a conventional centrifugal pump. There is a large gap between the impeller and the front end cover of the pump body (30-90mm), making this pump suitable for transporting corrosive liquids with large solid particles (particle size less than or equal to 20mm). In terms of structure, the impeller avoids the accident of the impeller being stuck due to solid particles, and overcurrent components such as the impeller are not prone to fouling, which overall solves the problems of short service life, frequent maintenance, and high equipment consumption.The pump shaft of the non-blocking cyclone pump adopts a heavy-duty shaft design, with strong load-bearing capacity and stable operation; the pump adopts a radial division, front door opening and rear door opening structure, which is convenient for maintenance.This pump type is suitable for transporting containing large particles of corrosive media.It has more reliable operation stability and stability.This pump has been widely used in chemical industry, fertilizer, petroleum, papermaking, metallurgy and other industries.The non-blocking cyclone pump is a new generation of pump products developed successfully based on the introduction of the technology and combined with the characteristics of domestic water pumps. It has the characteristics of energy-saving, anti-winding, non-blocking, automatic installation and automatic control.In terms of discharge of solid particles and long fiber waste, the non-blocking cyclone pump has a single fruit.Features of the non-blocking cyclone pump: 1. The pump and the motor are directly connected to the coaxial axis, and are mechatronics integrated products, with compact structure and stable performance.2. Design of large runner anti-blocking hydraulic components, greatly improving the ability to pass through dirt, and can effectively pass through 5 times the fiber substance and solid particles with a diameter of about 50% of the pump diameter.3. The non-blocking cyclone pump is designed reasonably, the supporting motor is reasonable, the efficiency is high, and the noise is low.4. The mechanical seal uses hard wear-resistant tungsten carbide, which has the characteristics of durability and wear resistance, and can ensure that the pump can run safely and continuously for more than 8,000 hours.5. The pump has a vertical structure, the center line of the inlet and outlet is on the same horizontal line, and the inlet and outlet flange specifications are the same, making it very convenient to install and disassemble.6. The area covers a small area and does not require building a computer room, which can save a lot of infrastructure costs; add protective covers to the end of the motor air blades, and the entire cyclone pump can be placed outdoors for work.